• About TPU
  • Research
  • Academics
  • Admissions
  • Cooperation
  • Life at TPU

13.02.2018 Science

Scientists from Tomsk Polytechnic University together with specialists from NTC Tekhnika proposed a thermal imaging method for non-destructive testing of railways. It enables efficiently and quickly detecting the corrosion of steel reinforcement hidden behind the concrete shell of the supporting structure. Developers have already studied 14 reinforced concrete pillars in Tomsk region. The outcomes of the study were published in Applied Sciences (IF 1.679).

 

 

TPU Professor Vladimir Vavilov, the head of R&D Laboratory for Thermal Control says: ‘Now, all railways in Russia are electrified, there is a great number of pillars for wires and auxiliary equipment along the railways. Like any construction, they have their service life, which is 50 years. As the service life expires, the pillars become unfit for use with obvious negative consequences. It is impossible to replace all pillars simultaneously. Therefore, it is necessary to identify those that should be replaced first. Ultrasonic testing is traditionally used for this purpose. Such testing takes up to one day. We propose thermal testing.

 

Here the process takes a few minutes and about an hour together with all preparation works.’

 

To test a pillar, an inductor is placed around it, which presents an antenna heating the reinforcement inside the pillar. It is enough to heat the reinforcement a few degrees higher than the ambient temperature. The pillar heated with the reinforcement radiates heat, which is detected with infrared cameras installed at a distance of several meters from the pillar. A thermogram, e.g. a colorful image in infrared rays, which shows temperature distribution at the tested surface, is transmitted from the cameras to the computer.

 

‘It is enough to test the bottom part of a pillar with a length of a meter. The fact is that the metal corrosion is most likely in the place contacting the ground. In places already damaged by corrosion, the reinforcement is thinner, it is otherwise heated, which is displayed on thermograms. Up to the point, a thermal footprint disappears when air gaps and corrosion products occur,’ explains the scientist.

 

Photo: A thermogram of a pillar without a defect (a) and with a defect (b)

 

For data processing, the developers also apply a unique algorithm, which proved itself well in other studies in the field of thermal imaging.

 

‘The experimental part of the study was carried out at the Trans-Siberian Railway using an experimental facility for conducting induction and infrared thermal imaging.

 

We tested 14 working pillars. Data obtained from infrared cameras was confirmed through ultrasonic and vibroacustic tests. Upon the test results, two pillars were replaced,’ says Valdimir Vavilov.

The study was supported by the Russian Science Foundation grant No.17-19-01047.

Was this page useful?